Factory source Step Blocks - Phased Array type A test block – TMTeck

Description
The Phased Array “Type A” Calibration Block is used during the initial setup and calibration of a phased array ultrasonic unit. This block can be used to perform tasks such as beam angle verification, calibration for wedge delay, sensitivity calibration, performing DAC/TCG, and more. This block has similar dimensions to an IIW-Type Block, but has been specially-engineered for phased array applications.

Inch
Blocks include both 4.000″ and 2.000″ radii, (19) through holes at 0.040″ diameter, (1) through hole at 0.080″ diameter, (4) FBHs at 0.080″ diameter x 0.080, 0.160, 0.235, and 0.315″ deep, (4) FBHs at 0.157″ diameter x 0.040, 0.120, 0.200, and 0.275″ deep, (3) FBHs at 0.080″ diameter x 0.120″ deep machined into the 2.000″ radius, and (4) EDM notches at 0.004, 0.008, 0.012, and 0.016″ deep x 0.020″ wide x 1.00″ long.

Block dimensions are 1.000″ thick x 4.000″ tall x 12.00″ long.
material: 1018 Steel, stainless steel , aluminum
plastic carrying case

Metric
Blocks include both 100.0mm and 50.0mm radii, (19) through holes at 1.0mm diameter, (1) through hole at 2.0mm diameter, (4) FBHs at 2.0mm diameter x 2.0, 4.0, 6.0, and 8.0mm deep, (4) FBHs at 4.0mm diameter x 1.0, 3.0, 5.0, and 7.0mm deep, (3) FBHs at 2.0mm diameter x 3.0mm deep machined into the 50mm radius, and (4) EDM notches at 0.1, 0.2, 0.3, and 0.4mm deep x 0.5mm wide x 25.0mm long.

Block dimensions are 25.0mm thick x 100.0mm tall x 300.0mm long
material: 1018 Steel, stainless steel , aluminum
plastic carrying case

Package including
1 calibration block
1 certificate  
1 block case